Press out differential bevel gear shaft
The tensioning sleeve is cut during pressing out.
– Remove the remaining parts of the tensioning sleeve out of
the differential gear housing and the differential bevel gear
shaft.
On certain gearboxes the stop disc compound was provided with
lands -A- in the area of the openings.
Therefore the differential gear housing was provided with a round
slot -B-.
– Install stop disc compound with gearbox oil.
– Insert the stop disc compound in such a way that it locks into
the slot -B- in the differential gear housing.
Install differential bevel gears
– Install stop disc compound with gearbox oil.
– Insert both large differential bevel gears and secure (e.g. with
flange shafts).
– Insert both small differential bevel gears with a 180° offset.
– Push in the differential bevel gear shaft -arrow A- up to the first
small differential bevel gear.
– Insert the threaded parts -arrows B- in the large differential
bevel gears.
Fitting position: Heel of the differential bevel gear.
– Insert the differential bevel gear shaft up to stop and secure
with new -Spannhülse- .
2.2
Adjusting the differential gear
Special tools and workshop equipment required
♦ Gauge block plate - MP3-405/17-
♦ Universal dial gauge holder - MP3-447 (VW 387)-
♦ Pressure plate - MP3-407 (VW 402)-
♦ Pressure plate - MP3-406 (VW 401)-
♦ Pressure spindle - MP3-408 (VW 412)-
♦ Pressure washer - MP3-413 (VW 510)-
♦ Pressure pipe - MP6-408 (30-14)-
♦ Pipe - MP6-419 (3259)-
♦ Tube for wheel bearing - T30019 (3345)-
♦ Drive bushing - MP3-427 (40-21)-
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
2. Differential gear
159
