IN THE BOX
GETTING STARTED
ADJUSTING
1. Place top and bottom net frame posts (A) on ground
with hooks facing up.
2. Insert middle net frame (B) to top of net frame using
push pins. Repeat on bottom.
1. On net support pole (C),
there are 5 adjustments to
change the angle of return.
Push large push pin to
move frame up or down.
2. To adjust net tension, remove tension cord from hooks on
back of net frame. Turn tension knob slightly clockwise
(this will feel tight). Hold net release lever down while
still holding tension knob. Once net release lever has
been pushed, let go of tension knob and pull out cord to
release the tension.
7. Insert right base frame leg (E) to right net frame (A) using
push pins. Repeat on other side.
8. With net on the ground, lift the base frame (D) to
connect net support pole (C) using push pin.
9. Once fully assembled, grab top of net frame (A) and
lift to stand upright.
10. Rotate tension knob on left side of net frame (A)
clockwise until net is pulled tight.
11. Once net has reached desired tension, take outer
tension cord and pull over hooks on back of net frame.
NOTE: Ensure you are using tension chord and not the
outside of the net. You may need to retighten net after
initial use.
4. Connect top and bottom support poles (C) using the
large push pin.
5. Insert top of support pole to net frame using push pins.
NOTE: Ensure pole with adjustment holes is closest to net.
6. Assemble the base frame. Connect right base leg (E)
to back of base frame (D) using push pin. Repeat on
other side.
NOTE: Ensure the long side of the base legs are inserted
into the back of the base frame.
VISIT SKLZ.COM TO LEARN MORE
MIDDLE NET FRAME
TOP AND BOTTOM
NET FRAME
TOP AND BOTTOM
SUPPORT POLES
BACK OF
BASE FRAME
RIGHT AND LEFT
BASE FRAME LEG
B
A
C
D
E
