SKIMO – AIR CONDITIONING UNIT
CODE PRODUIT : 320B12 / 320B17
INSTALLATION, USER AND MAINTENANCE MANUAL
Page 16/22
15.c To replace the receiver dryer and the evaporator foam:
1. Remove the cover and recover the
A/C unit gas (see section 15.a).
2. Remove the 4 condenser fastening
screws, disconnect the 2 A/C pipes
connected to the condenser, and
remove the condenser.
3. Remove the 6 fastening screws of
the evaporator casing cover and
remove the cover.
4. Take the receiver dryer fastening
screw off (circled in blue), and
disconnect the receiver drier connector
on the expansion valve side (circled in
red). Remove the compressor flange
and the compressor-condenser pipe,
and remove the receiver dryer.
5. Remove the receiver dryer-
condenser pipe and the pressure
switch from the used receiver dryer
and fit them to the new receiver dryer.
6. Lift the evaporator and change the
evaporator foam. Put the evaporator
back into place.
7. Assemble all the parts back in
reverse order (steps 4 to 2). Charge
the A/C system and test it (section
15.a)