Skil PWRCORE 20 QC5359E-00, Owner'S Manual, Page: 5 / 8

5
• Do not touch the contacts in the
charger
• Do not expose tool/charger/battery
to rain
• Do not charge battery in damp or wet
environments
• Do not use charger when damaged
• Do not use battery when damaged; it
should be replaced immediately
• Do not disassemble charger
• Do not attempt to recharge non-
rechargeable batteries with the
charger
• Permitted ambient temperature
(charger):
- when charging 4...40°C
-
during operation –20...+50°C
- during storage –20...+50°C
EXPLANATION OF SYMBOLS ON
CHARGER
3
Read the instruction manual before
use
4
Only use the charger indoors
5
Double insulation (no earth wire
required)
6
Do not dispose of electric tools and
batteries together with household
waste material
7
Time lag fuse (QC5359E-00)
USE
• Charging battery
8
- This charger can charge a single
battery pack, but also 2 battery
packs at the same time.
-
remove battery from tool
- connect charger to power source as
illustrated
8
a
- both lights turn on for 1 second and
then turn off again
8
b
- insert battery into charger as
illustrated
8
c
- green light starts flashing indicating
that the battery is being charged
8
b
-
when the battery is fully charged
and green light turns on
8
d
-
remove battery from charger as
illustrated
8
d
-
Charges a fully depleted 2.5Ah
battery pack to approximately 25%
capacity in 6 minutes
INTRODUCTION
• This charger is intended for charging
SKIL battery packs BY5197E-03
BY5196E-03
• This tool is not intended for
professional use
• Read and save this instruction manual
3
SAFETY
SPECIFIC SAFETY
INSTRUCTIONS FOR
CHARGERS
• This charger can be used by
children aged 8 and above and
by persons who have physical,
sensory or mental limitations or a
lack of experience or knowledge
if a person responsible for their
safety supervises them or has
instructed them in the safe
operation of the charger and
they understand the associated
dangers (otherwise, there is a danger
of operating errors and injuries)
• Supervise children (this will ensure
that children do not play with the
charger)
• Cleaning and user maintenance
of the battery charger shall not
be made by children without
supervision
• Always check that the supply voltage
is the same as the voltage indicated
on the nameplate of the charger
• In case of electrical or mechanical
malfunction, immediately switch off
the tool or unplug charger from power
source
• If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
• Recommendation that the tools
always be supplied via residual
current device with rated residual
current of 30 mA or less
• Only use SKIL battery packs
BY5197E-03 BY5196E-03 with this
charger