8
SKF TKDT 10
7. Setup mode
U
se the Setup Mode to change different parameters.
The thermometer stores the settings in its memory.
7.1 Setup options
Option
Menu item
Settings
Type
TYPE
K
Offset
OFFSET
T1 or T2
Sleep Mode
SLP
On (sleep mode on) or
0FF (sleep mode off)
7.2 Entering or Exiting Setup
When the thermometer is in Setup mode, the display shows
SETUP
.
Press
Set
button for 3 seconds to enter or exit Setup mode.
7.3 Changing a Setup Option
1. Press
HOLD
or
MAX
MIN
to scroll to the setup option you want to change.
2. Press
Enter
to indicate that you want to change this setting.
3. Press
HOLD
or
MAX
MIN
until the setting you want to use appears on the
display.
4. Press
Enter
to store the new setting in memory.
Note:
Setup is disabled in MAX/MIN mode.
7.4 Offset correction
Use the offset option in Setup to adjust the thermometer’s readings
to compensate for the errors of a speciic thermocouple.
The allowable adjustment range is ±5,0 °C or ±9.0 °F.
1. Plug the thermocouple into the input connector TI or T2.
2. Place the thermocouple in a known, stable temperature environment
3. Allow the readings to stabilize.
4. In Setup Mode change the offset until the top reading matches the
calibration temperature.
7.5 Auto Power Off
The thermometer will automatically switch off after 20 minutes if no
button is pressed during this time.
In Setup mode:
Press
HOLD
or
MAX
MIN
to scroll to the
“SLP”
page. Press
Enter
to indicate
“On”
or
“OFF”
. Press
HOLD
or
MAX
MIN
until the setting you want to use
appears on the display.
Press
Enter
to store the new setting in memory.
On
(sleep mode on) or
0FF
(sleep mode off).
ООО
"
Индастриал
Партнер
"
Авторизованный
дистрибьютор
SKF
www.skf.indpart.ru
8(495)223-07-69
Техническая
поддержка
:
[email protected], 8(495)223-07-69
