SNB-B24 BANDSAW MANUAL
4
6/2016
2.
USE AND APPLICATION
The SNB-B24 is suitable for wood, plastic applications. Some features include
sawing, re-sawing, cross cutting & angle cutting.
Main Characteristics:
i)
Narrow saw blade which provides for a smooth cutting surface therefore saving
material.
ii)
Special steel wheel to ensure a smooth and steady cut.
iii)
Strong welded machine base.
iv)
Light top and bottom pulley with a special guide system.
3.
SPECIFICATIONS
(a)
Motor Power-------------------------------------------------3kw
(b)
Power Source------------------------------------------------3Phase / 220v / 60Hz
(c)
Saw Wheel Speed------------------------------------------800 r/min
(d)
Saw Wheel Diameter---------------------------------------24” inches (600mm)
(e)
Table Tilt Angle-----------------------------------------------0-20
°
4.
OPERATION
1.
Before operating the SNB-B24, please ensure that all run parment are well
prepared.
2.
First, pull the blade over the top pulley, turn the knob slightly to stretch blade. Check
that the teeth of the blade are facing the cutting direction and that the blade passes
between each guide. Saw blade surface will appear about 3/16” (5mm) of the side of
the top pulley and bottom pulley’s same side will be in the same plane. Turn pulley
round by hand to check the position. If not aligned, adjust the screw on the rear of
the machine support (diag. A), or adjust the bottom wheel screw (diag. B).
Summary of Contents for SNB-B24
Page 1: ...SNB B24 24 BAND SAW MANUAL...