3-17
Table Of Contents
www.SkeeterBoats.com
BASS BOATS
EMPTY – On/Off plane: Actuator in “EMPTY”
position, drains the livewell but does not allow water
to re-enter.
Rinse the livewell and baitwell (if equipped) with
fresh clean water, remove any debris from the pick-
up and drain screens, and allow the livewell to air-
dry after each use. The pick-up screens are located
at the bottom of the transom and the drain screens
are located in the livewell or baitwell.
Before filling the livewell, make sure of the following:
• Transom strainer(s) are clean and secured to the
water inlet on the transom.
• The boat is in the water, at rest position with
unrestricted water flow to the water inlet on the
transom.
NOTE: The livewell cannot be filled while the
boat is running.
To fill the livewell:
1. Close the actuator to the livewell. The actuator
opens and closes the livewell drain valve.
2. Open the fill valve inside the livewell. The fill valve
is located on the fill nozzle at the top of the inside
of the livewell.
LIVEWELL OPERATION – 3-WAY VALVE SYSTEM (Cont.)
FILLING THE LIVEWELL – 2-WAY VALVE SYSTEM
Livewell Actuator Settings
Figure 3-15
Livewell Fill Water Flow
Figure 3-16
