8
(C) Copyright 2010-2014 SKD System AB
SW2
Turn AC2 on/off when AC2 is not controlled by Sensor2.
AC2 is controlled by Sensor2 if LED2 is Red.
Other functions of SW2: Initite firmware upgrade and restore factory defaults.
For firmware upgrade: Hold SW2 while USB-memory with new firmware is inserted into USB-interface while powering on the
product.
For restoring factory defaults: Hold SW2 for around 15 seconds until fast blinking stops.
LED function
LED1
If off: AC1 is disconnected.
If Green: AC1 is turned on activated by SW1, command or via Android.
If Red: Sensor1 is activated and controls AC1.
If Orange: AC1 is on, activated by Sensor1.
LED2
If off: AC2 is disconnected.
If Green: AC2 is turned on activated by SW2, command or via Android.
If Red: Sensor2 is activated and controls AC2.
If Orange: AC2 is on, activated by Sensor2.
Fast blinking Green: When holding for SW2 for 15 seconds to initiate restoring factory defaults.
Indirect Connection Over WiFi
Connection between skdRhone2 app in Android and the product can be set upp by selecting product IP address in the app. See:
Network page -> Node IP.
If current IP of the product is not in the Selection list, add node address to the list.
After each change of WiFi connection settings, Close app and start app again to ensure that the changes are activated in the app.
Illustration of control of AC switch and sensors via WiFi:
