Installation Instructions
Mounting the control panel
1.
Determine mounting location for panel. If distance
exceeds the length of the fl oat switches or pump,
splicing will be required.
You must use conduit
sealant to prevent moisture or gases from enter-
ing the panel.
2.
Mount control panel using the mounting fl anges
furnished with control panel.
3.
Determine conduit entrance locations on control
panel. Check local codes and schematic for the
number of power circuits required.
NOTE:
Be sure the incoming power, voltage, amper-
age, and phase meet the requirements of the pump
motor being installed. If in doubt, see the pump
identifi cation plate for electrical requirements.
4.
Drill proper size holes for type of connectors being
used.
5.
Attach cable connectors and/or conduit connectors
to control panel.
FOR INSTALLATION REQUIRING A SPLICE,
FOLLOW STEPS 6-10;
FOR INSTALLATION WITHOUT A SPLICE,
GO TO STEP 11.
6.
Determine location for mounting junction box(es)
according to local code requirements.
7.
Mount junction box to proper support according to
local codes.
8.
Run conduit to junction box(es). Drill proper size
holes for the type of conduit used.
9.
Identify and label each wire before pulling through
conduit into control panel and junction box(es).
Make wire splice connections at junction box(es).
10.
Firmly tighten and seal all fi ttings on junction
box(es).
11.
If a junction box is not required, pull cables
through conduit into control panel.
12.
Connect pump wires and fl oat switches to proper
position on terminals. See schematic inside control
panel for terminal connections.
NOTE:
It is the recommendation of the factory to use
separate pump and control/alarm power sources.
VERIFY CORRECT OPERATION OF CONTROL
PANEL AFTER INSTALLATION IS COMPLETE.
4.
Tighten the hose clamp using a screwdriver. Over
tightening may result in damage to the plastic clamp.
Make sure the fl oat cable is not allowed to touch
the excess hose clamp band during operation.
NOTE:
All hose clamp components are made of
18-8 stainless steel material. See SJE-Rhombus
®
for replacements.
FIGURE 1 - Simplex
Four fl oat system
FIGURE 2 - Duplex
Four fl oat system
FIGURE 3 -
Mouning Clamp Detail
