Remove all the nuts for the switches and pots but leave the washers in
place. Place the acrylic panel over the PCB being careful to prevent the
piezo wires from crossing over each other or getting trapped in front of one
of the washers. Then replace the nuts
At this point locate the four M3 washers and slide them in between the PCB
and front panel around the four lower holes (see position of bolts in picture
above). Dropping the M3 x 12mm hex bolts (the four longer bolts) through
the holes will keep the washers in place
Summary of Contents for PCLONE2
Page 24: ......