sitrex GS 160, Use And Maintenance

Page: 10 / 24

8
SAFETY PRECAUTIONS
2.22
The correct position in which the operator should sit
during the productive cycle is always at the tractor
wheel, as from this position, he can not only observe
the entire productive cycle, but he can also see if
any person is within range of the machine at the
same time.
2.23
Remember to reset all the safety devices and
replace and/or close their protective casing after
every cleaning, lubrication, adjustment and
maintenance operation.
2.24
When maintenance or repairs are finished, before
starting the machine, check that no tools, cloths or
other materials have been left in the various
compartments containing moving parts or near any
moving parts.
2.25
At the end of the work cycle it is severely forbidden
to leave the machine, equipment and parts in
potentially dangerous conditions.
2.26
If you should decide to replace worn and/or broken
parts, only use original spare parts.
2.27
During installation of the propeller shaft, the operator
must carry out the correct attachment procedure and
he must make sure that it is firmly fastened to the
belt rake.
2.28
When the machine come to the end of its working
life, do not throw it away in the environment. Contact
iron disposal agencies or the manufacturer directly,
who will give you instructions. In any case, before
you hand over the machine, fasten the moving parts
and handle as described in the chapter on transport
and handling (part 4).