4
GS869
MANUAL
REV
E
Installation
This gas detector must be installed by a competent person.
The gas installation and shut-off device (where used) must comply with
the appropriate national regulations.
Electricity must be turned off before beginning installation to prevent
electrical shock or equipment damage.
Connect the output signal wire with the solenoid valve. (If applicable,
please refer to next section)
Having established the mounting location ensures that there is no electrical
wiring or pipe work in the area next to the mounting surface.
Mark the proper location on the wall according to the two holes of the
bracket of alarm. (Refer to diagram 3)
Drill two
ф
5.0mm holes in the wall, then insert the plastic plugs into the
holes.Attach the bracket to the plastic plugs and fix tightly the screws into the
plastic plugs.Fit the alarm on the bracket and pull it down until matching well
on the bracket.
Insert the power plug into the socket after installation, the power light will
be on. the gas detector will be in self- detection for about 3 minutes. During this
period, green LED is flashing.When it stops,the green LED is constant on, and
the detector is ready for use.
Additionally, any changes to the gas installation, e.g., fitting of an
automatic gas shut-off valve, must be carried out by a person qualified to the
national regulations for gas installations.
Note for installation of solenoid valve:
To prevent the possibility of death, serious injury or property damage,
close the electricity and gas supply pipeline before installation.
Removing impurities like metal powder and rust from the pipeline.
Ensure the solenoid valve is horizontal, i.e., the input and output port of
solenoid valve must keep on the horizontal level.
The solenoid valve can’t mount reversely, while there is a mark for gas
flow direction on the valve. (Refer to diagram 4)
External leakage tests must be carried out after installation.
Have any problem caused by solenoid valve, please call our agent.
Diagram 3
Diagram 4
Manufacturer:
SITERWELL ELECTRONICS CO., LIMITED
ADDRESS: No.666 Qingfeng Road, Jiangbei District, Ningbo, Zhejiang Province,
China
TEL: 0086-574-87729581
FAX: 0086-574-87729581
E-MAIL: [email protected]
URL: www.china-siter.com
