Document NO.: RD-536-39-001 Version: C
- 3 -
testing.
Test the alarm weekly to ensure proper operation. Erratic or
low sound coming from your alarm may indicate a defective
alarm, you can refer to “Trouble shooting” section for
solution.
NOTE: WEEKLY TESTING IS REQUIRED.
LED indicators
This alarm is equipped with a red LED indicator, with two
modes of operation
Red LED-Flashing every 32 seconds: indicates that thesmoke
alarm is operating properly.
RED LED-Flashing: when the Test button is pressed, or
when the smoke alarm sense particles of combustion and
goes into alarm(constant pulsating sound),the red LED will
flash once per second. The flashing LED and pulsating alarm
will continue until the air is cleared
Fault indication -
The unit will generate a "chirp" between
two flashes every 32 seconds when the unit goes into fault
mode.
NOTE: WEEKLY TESTING IS REQUIRED.
DANGER:
If the alarm sounds, and it is not being tested, it
means the unit is sensing smoke,
THE SOUND OF THE
ALARM REQUIRES YOUR IMMEDIATE ATTENTION AND
ACTION.
Maintenance and Cleaning:
In addition to weekly testing, the alarm requires periodic
cleaning to remove dust, dirt, and debris.
Clean the alarm at least once a month to remove dust, dirt, or
debris.
Use a vacuum cleaner with the soft brush, vacuum all sides
and covers of smoke alarm device.
This alarm has a low battery monitor which will cause the
alarm to “chirp” approx every 32 seconds and the red LED
flash once at the same time for a minimum of thirty days
when the battery gets low.
If there is a defective battery or other failures, you can refer
to “Trouble shooting” for solution, if there are still failures
during warranty, you can return to your retailer..
IMPORTANT:
Do not attempt to remove the cover to clean
inside. This will affect warranty.
Repair:
Caution: Do not attempt to repair the alarm. It will affect
your warranty.
If the alarm is not operating properly, and is still under
warranty, return it to the original place you buy. Pack it in a
well-padded carton, and ship to the original place you buy.
If the alarm is no longer under warranty, have a licensed
electrician replace it immediately with a comparable alarm.
Trouble shooting:
Problem
Method of disposal
Smoke alarm device
does not sound when
tested.
1.
Fit the alarm on the bracket
and turn the alarm body
clockwise, until matching
well on the bracket.
2.
Clean smoke alarm device.
Please
refer
to
the
“maintenance and cleaning”
section.
3.
If there are still failures
during warranty, you can
return to your retailer.
4. If the unit is out of warranty
，
please replace another new alarm.
The alarm “chirp” with
red LED flashes once
every 32 seconds.
The battery is under low battery
status, please replace the smoke
alarm device.
Smoke alarm device
chirp occurs every
32 seconds
（
alarm goes
into fault mode
）
.
Clean smoke alarm device. Please
refer to the “maintenance and
cleaning” section. Purchase and
change another smoke alarm
device if the problem still exist
Smoke alarm device
sounds
unwanted
alarms intermittently or
when
residents
are
cooking,
taking
showers, etc.
1. Press test button to pause
alarm.
2. Clean smoke alarm device.
Please
refer
to
the
“maintenance and cleaning”
section.
3. Move smoke alarm device to
new location and press test
button.
The
alarm
sounds
different from it is used
to. It starts and stops.
1. Clean smoke alarm device.
Please
refer
to
the
“maintenance and cleaning”
section.
2. If there are still failures during
warranty, you can return to
your retailer.
3. If the unit is out of warranty
，
please replace another new alarm.
