Sitecom LN-520, User Manual

Page: 6 / 33

Full manual Sitecom Homeplug 6
3. Introduction of the hardware
Power LED
ON: Power on and ready.
BLINKING:
1.
(blink at slower rate) means Standby mode, or
2. During Group pairing procedure , the device joining or being joined into
same logical network will continue to blink for 2 minutes until the procedure is
successful or is canceled). To enter or cancel the
Group pairing procedure ,
just press the GROUP button 2~3 sec.
OFF: Power off.
PLC Link/Activity
LED
ON: Power line Link detected but no power line traffic.
BLINKING:
1. Fast blinking (0.06 s ON/ 0.06 s OFF): Power line data rate higher than
60Mbps.
2. Normal blinking (0.2 s ON/ 0.2 s OFF) Power line data rate between10Mbps to
60Mbps.
3. Slow blinking (1 s ON/ 1 s OFF): Power line data rate slower than 10Mbps.
OFF: Power line Link not detected (either other devices in same network are too
far to communicate or it is alone in its logical network).
Ethernet
Link/Activity LED
ON: Ethernet Link Detected.
BLINKING: Ethernet traffic detected.
OFF: No Ethernet Link detected.
GROUP button Reset button
Power LED PLC Link/Activity
Ethernet Link/Activity