BA_ST_TX-MATIC_EN_08-22.docx
8
Figure 11: Planing of workpieces with small cross-sections and planing of workpiece sides
Figure 12: Planing short parts
Figure 13: Bevelling along the dressing fence
8
Handling during Knife Change
The knife change must generally be carried out in accordance with the operating instructions
of your machine. With regard to the bridge guard, please also follow the instructions below
Changing the Knives from Above
Pull the TX MATIC bridge guard forward as far as it will go and change the planing knives according to the man-
ufacturer's instructions and the operating instructions for your machine.
Changing the Knives from the Front
Set the TX MATIC bridge guard to its uppermost position (75 mm above the table) and change the planing knives
according to the manufacturer's instructions and the operating instructions of your machine.
After Changing the Knives
After changing the knife, return the guard to its protective position so that the entire cutter block is covered.
Push stick
Push stick
Push stick
