Do not use
any hand drill
on this product
PHILLIPS SCREWDRIVER
( not included )
1- After laying out all components, position the Seat ( B ) upside-down and align the Back Leg Assembly ( C ) with
the Seat Supports, as shown below. Insert a Screw ( A ) through a Seat Support into a predrilled hole and begin to
tighten the screw with a screwdriver. Once the screw is a few turns tightened, move on to another screw until all 6
have been started. Leaving these loose will allow the Bench to adjust in the next procedure.
Figure 1
Hardware and Parts
C
( Back Leg
Assembly )
B
( Seat )
D
( Front Leg
Assembly )
E
( Stretcher )
With the Seat Supports attached to the Back Leg, the Leg Supports can be attached. Insert a Screw ( A1 ) into
the hole on the bottom side of the Leg Support. Tighten them with a screwdriver. Once all 6 screws have been
tightened, go back and finish tightening the screws from Step 1.
Seat
Support
Leg
Support
C
A
A1
(24)
A
1.50
(12)
A1
2.50
( Back Leg
Assembly )
B
( Seat )
B
( Seat )
C
( Back Leg
Assembly )
Item No: MHUD-B47B
Hudson 47" Bar Height Bench
Assembly Instructions
