Pass the SDI-12 cable through the
hole closest to the bottom of the
box. The straight sides should be
parallel to the bottom of the box.
6
IMPORTANT: On the inside,
the black notch should be
parallel to the bottom of the
box.
7
Assemble the SDI-12 board
and four analogue inputs with
the two SHR screws.
11
Replace the base plate and its five
screws back in the controller.
8
It is recommended to fasten the
inner notches with a little glue
to prevent them from moving
when screwed on the outside.
10
Pass the second cable
following the same indications
as the first.
Connect the other side of the link
board cable to the keyboard board.
Connect the coloured cables
to the terminal as shown in the
image:
9
13
14
Connect the board link
cable to the SDI-12 board
and 4 analogue inputs.
12
Connect the terminal to the SDI-
12 board and 4 analogue inputs.
Close the controller by refitting
the four screws removed at point 2.
16
17
Reconnect the cables
between the two boards.
15
If the Plus option is not
showing on the controller, it must
be activated. If all steps have
been completed, the installation
is complete. Finally, configure the
controller referring to the A-2500
Plus manual and the SDI-12 option
manual.
18
R-2369
RECESSED FORMAT ASSEMBLY
For the recessed format, follow the same steps as the box format, changing points 4 and 11 to:
Break the die with a gentle
strike using a screwdriver or
similar.
Assemble the SDI-12 board
and four analogue inputs
with the two SHR screws.
4
11
Put insulating tape on the sheet,
between the drawer and the plate.
Bend the ground cable terminal of the
SDI-12 board and four analogue inputs
so that it is in contact with the drawer.
IMPORTANT
