1
2 x
RUBBER
WASHER
*ORDER MUST BE RESPECTED TO GUARANTEE
WATERTIGHT INSTALLATION
2
2 x
METAL
WASHER
3
2 x
NYLTITE
WASHER
DIRECT FEED INSTALLATION (DF) - LOW VOLTAGE (24V) REMOTE DRIVER (REM)
MINICOOL SQUARE
MODEL : S7281
INSTRUCTIONS SHEET
PAGE: 1 of 5
A- PREPARE SURFACE FOR INSTALLATION (
SEE DIMENSIONS BELOW
). *INSERT (
2
) ANCHOR SCREWS (
NOT INCLUDED
) IF NECESSARY.
B- UNFASTEN THE SET SCREWS WITH AN ALLEN KEY (
INCLUDED
) TO REMOVE THE FIXTURE FROM THE BASE.
DO NOT COMPLETELY REMOVE THE SET SCREWS.
C- INSERT THE LIQUID TIGHT GROMMET INTO FIXTURE BASE.
D- PASS EXTERIOR CABLE THROUGH LIQUID TIGHT GROMMET.
E- USING (
2
) #8 COUNTERSINK SCREWS (
NOT INCLUDED
) AND (
6
) WASHERS (
INCLUDED
), INSTALL THE FIXTURE BASE TO THE WALL.
*TO GUARANTEE A WATERTIGHT INSTALLATION, MAKE SURE TO INSERT THE WASHERS IN THE CORRECT ORDER (
SEE BELOW
).
F- MAKE ALL NECESSARY WIRE CONNECTIONS INTO THE CONNECTOR BLOCK USING A SCREWSDRIVER (
SEE WIRING DIAGRAM BELOW
).
G- FASTEN THE FIXTURE ON ITS BASE WITH THE SET SCREWS WITH AN ALLEN KEY (
INCLUDED
).
E
F
G
IMPORTANT -
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE AND ALL APPLICABLE LOCAL CODES, BY A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THE PRODUCT, AND THE HAZARDS INVOLVED. PROPER GROUNDING IS REQUIRED FOR SAFETY.
DISCONNECT THE MAIN LINE BEFORE WIRING SECONDARY CONNECTORS.
LIQUID TIGHT
GROMMET
(INCLUDED)
C
B + C
FIXTURE
FIXTURE
BASE
*ANCHOR
SCREWS
(NOT INCLUDED)
A
D
5"
(127mm)
Ø3/16" - 3/8"
(Ø5 - 9mm)
FLAT HEAD
SCREWSDRIVER
#8 COUNTERSINK SCREWS
(NOT INCLUDED)
INS-479
9320 Boul. St-Laurent, suite 100, Montréal (Québec) Canada H2N 1N7
P.: 514.523.1339 F.: 514.525.6107 www.sistemalux.com
JP - R2
Last update: February 18, 2020
FEED
POSITION
1.32"
(33.6mm)
2.36"
(60mm)
0.53"
(13.4mm)
4.72"
(120mm)
B
SET SCREWS
ALLEN KEY
(INCLUDED)
EXTERIOR
CABLE
FIXTURE
BASE
LIQUID TIGHT
GROMMET
1 2
3
FIXTURE
FIXTURE
BASE
SET SCREWS
ALLEN KEY
(INCLUDED)
CONNECTOR
BLOCK
CONNECTOR BLOCK
WIRING DIAGRAM (24V)
+
-
LED +
LED -
