Siruba DL918, Manual

Page: 13 / 42

G 13
償
Adding Stitches for Start
/ End Tacking
時，在各段的設定針數內自動
追加
0~99
針
(
註
:
需在
"028"
為
ON
時才有效
)
When executing start / end
tacking, it will automatically
add 0~99 stitches. (Note: the
function will be valid only when
“028” was set ON.)
30
終止回缝
C
段多加
1
針
Adding 1 Stitch to the
Stitch C of End Tacking
ON/OFF OFF
ON:
當執行終止回缝功能時，
再第一段的
C
段內自動追加一
針。
ON: When executing end
tacking, it will automatically
add 1 stitch in C Section.
OFF:
無效
OFF: The function is invalid.
31
自動連續回缝運動模
式
Mode Selection for Bar
Tacking
A/M/SU/SD A
A:
往前輕觸踏板，即自動執行
完起始回缝段針數。
A: One Shot Sewing.
M:
受踏板控制可任意控速與
停止。
M: Motor can adjust speed and
stop during operation via foot
pedal control.
SU:
於各段轉角處自動暫停針
上後，始繼續執行下一段針
數，暫停時間由參數
"027"
調整
控制。
SU: One shot sewing while
motor stops at needle UP with
few ms interruption at end of
each seam. The interruption
time set by “027” timer.
SD:
於各段轉角處自動暫停針
下後，始繼續執行下一段針
數，暫停時間由參數
"027"
調整
控制。
SD: One shot sewing while
motor stops at needle DOWN
with few ms int
erruption at end
of each seam. The interruption
time set by “027” timer.
32
連續回缝功能
Bar Tacking Function
ON/OFF OFF