Siruba ASL-JBH100, Original Instructions Manual, Page: 20 / 44

接頭檢測的調整
THE ADJUSTMENT OF SPLICING
DETECTOR
接頭檢測板①下降的時候，與接頭檢測承軸②
之間的間隙，大約為布料厚度的
3~4
倍。 接
入空氣，按著重設按鈕的同時打開電源開關，
調整會變得容易操作。（調整後，關閉電源）
【調整方法】
⑴微調的情況
鬆開閉鎖螺絲③，旋動調整螺絲來進行調
整。
⑵進行大量調整的情況
鬆開螺絲④，將把手⑤沿著箭頭方向移動
進行調整。
As splicing detector plate
①
getting lower,
its gap between splicing detector shaft
②
is
about three or four times thickness of fabric.
Put into air, press Reset switch and turn the
power on simultaneously, which could make
operation easier.
（
Turn off power after
adjustment.
）
【
Adjustment
】
⑴
Fine adjustment
Loosen lockscrew
③
, turn adjusting screw
for fine adjustment.
⑵
Large adjustment
Loosen screw
④
, move handle
⑤
to the
arrow direction for adjustment.
④
③
⑤
② ①
布料厚度 ×
(
３～４
)
Thickness of fabric
×
(
３～４
)
P12