Siruba 700KST, Instruction Book, Page: 28 / 62

(2)
依照桌板，調整下勾針Ａ的距離設定，下
勾針會從第一針孔穿過
1.3mm
的位置。
(
圖
31)
(3)
當下勾針向右移至針中心時
(
雙針以左針
)
針與勾針之間隙為
0~0.05mm
。
(
圖
31)
(2)Based on the table, adjust the distance
setting of the lower lopper A. The lower
looper will pass from the first needle hole
through the position of 1.3mm. (Fig.31)
(3)The clearance between the needle and the
looper is 0~0.05mm, when the lower looper
moves rightward to the center of the needle
(The left needle is main while using double
needles) (Fig.31)
P22
圖
30 / Fig. 30
圖
31 / Fig. 31
2.
針與下勾針之關係
(1)
當下勾針移至最左時，勾針尖端與針中心
距約
2.8~3.0mm(
雙針時以左針為主
)
。
(
圖
30)
2. Relation between the needle and the looper
(1)The distance between the tip of the looper
and the center of the needle should be
2.8~3.0mm when the lower looper moves
the extreme left. (The left needle is main
while using double needles) (Fig.30)