65 64 020 D3650
D3650
.
201.01.02
.
02 04.2016
121
Sirona Dental Systems GmbH
4 Operation
Operating Instructions Simulation Unit SIM MODULAR
4.9 SIVISION digital video system
båÖäáëÜ
4.9.2.3
Connecting the SiroCam F / AF / AF+ intraoral camera
Connecting the intraoral camera to the TS dentist element
Depending on the equipment version, the intraoral camera can be placed
at instrument position five or in the additional holder.
The intraoral camera is connected on the bottom side of the dentist
element.
➢ Plug the connector of the intraoral camera into the socket on the
dentist element.
The plug locks in place.
Connecting the intraoral camera to the CS dentist element
The connecting cable of the intraoral camera is guided through a swivel
arm. The camera connection is located underneath the instrument holder.
The holder is fixed on the front edge with two internal clamps on the
dentist element.
1. The instruments must be removed from the instrument holder. To do
this, remove all instruments one after the other and allow these to
hang down in front of the dentist element.
2. Lift the instrument holder by the front edge until the clamps are
released and the holder can be removed.
3. The connection for the intraoral camera is located at the fifth
instrument position. Insert the connection cable of the camera in the
swivel arm and insert the camera connector into the socket.
The plug locks in place.
4. First insert the rear edge of the instrument holder into the groove on
the dentist element. Then push the holder forward and down until it
locks into place.
5. Place the instruments in their holders. Make sure that the instrument
hoses and the connection cable of the camera are located in the
guide rollers of the swivel arm.
