Sirman Sinfonia 2, Use And Maintenance Manual

Page: 7 / 10

14
7 - Maintenance
7.1 Prescriptions
WARNING! All maintenance and cleaning intervention must only be carried out with
the machine shut down and disconnected from the mains.
The area where maintenance is performed must always be clean and dry.
Do not
allow unauthorized personnel to operate on the machine.
Any possible replacement of components, including the replacement tools, must be
carried out with original spare parts by authorized workshops or directly by the man-
ufacturer.
7.1 - Lubrication
The machine does not require lubrication.
7.2 Cleaning the machine
WARNING! Unplug the machine from the mains before cleaning.
Do not wash the machine with pressurized water jet.
Use non toxic detergents and expressly intended for the cleaning of food compo-
nents.
7.2.1 – How to remove the tools
At the end of each work cycle, in order to clean the machine you must remove the
work tools
How to remove the mixer blade:
1 – Put blade “1” in position as shown in fig. 7.2.1
2 – Lift lever “2” and pull out rod “3”
3 – Remove blade “1” by pulling it upwards.
WARNING! If the blade is not locked in position
as shown in fig. 7.2.1 it cannot be removed.
How to remove the propeller
1 – unscrew nut 4
2 – remove draw-plate 5
3 – remove propeller 6
WARNING!
After each kneading, ensure the propelling pivots are thor-
oughly cleaned so the blade and Archimedean screw can be
properly assembled (fig 7.2.2)
Fig. 7.2.2
1
Fig. 7.2.1
2
3
5
4
6
7
English
- Do not use the equipment if damaged.
- Before using the machine make sure that any dangerous condition has been
appropriately cleared. In case of abnormal operation, stop the machine and warn the
persons in charge with maintenance.
-
Do not allow unauthorized persons to operate on the equipment.
The emergency treatment in case of an accident caused by electrical shock
implies to first remove the contact between the injured person from the conductor
(since usually the person faints). This is dangerous operation. The victim in this
case is a conductor: touch him/her could imply being electrocuted.
It should therefore first be remove contacts directly from the supply valve,
otherwise move the victim using insulating materials (wood or PVC stick, cloth,
leather, etc.). It is recommended to call for medical staff, the patient has to be
transferred to a hospital.
1.7 - Identification of the equipment
Providing an exact description of the "Version", the "Serial Number" and the '' Year
of manufacture" of the machine will allow rapid and effective answer from our cus-
tomer service. It is recommended to indicate the machine version and serial num-
ber whenever you call for service.
Collect these data from the plate shown in Fig. 1.7.1. It is suggested to insert the ma-
chine identification data in the following table:
WARNING!
Do not alter the data on the identification plate under
any any circumstances.
Machine version…………………………..
Serial No.…………………………………..
Year of manufacture……………………...
Type………………………………………...
A = machine version
B = Voltage
C = motor power
D = motor frequency Hz
E = Weight
F = Amperage
G = Year of manufacture
H = Serial No.
I = Manufacturer
L = Barcode
A
B C
D E
F G
H
I
L
Fig. 1.7.1