Sirius Satellite Radio SLEM83, Installation Instructions Manual

Page: 5 / 12

5
1. The rangehood is quite heavy, so two people
will be needed for installation.
2. Before connecting any ducting to the motor,
make sure the non-return valves - which are on
the air outlet of the motor - can swing open.
3. Using the supplied bracket template (pg. 10),
mark the location of the holes that need to be
drilled in the wall, being careful to make sure
that the wall behind is clear of electrical wiring,
plumbing, pipes etc. Note: Be sure to set the
height of the rangehood between the minimum
and maximum height requirements as per
diagram Fig. 1 (Pg. 3). This can be done by
measuring from the lowest point of the rangehood
to the horizontal support bar. (1200mm
rangehood - Fig. 4.
NOTE: Model measurements will vary.
Please check specific model specs.
4. Using an 8mm drill bit, pre-drill the holes that
will hold the brackets to the wall. (Using bracket
template).
SL83 FRESCO RANGEHOOD
INSTALLATION - OFFBOARD MOTOR
Before installing the appliance, make sure that
none of the parts are damaged in any way. In
case of damaged parts, contact your retailer
and do not proceed with installation. Read all
of the following instructions with care before
installing the appliance.
• Use ducting within the min/max specifications
• Limit the number of ducting bends.
• Do not make any changes in ducting diameter:
Must be Ø 200 mm or equal surface area for
1200mm rangehoods.
Before installing the appliance - in order not to
damage the appliance itself - the metal grease filter
should be removed. These filters could be removed
by pushing the handles towards the back side of the
rangehood and pulling it downwards to unfasten it
from its slot. (Fig.3).
NOTE
CAUTION
WARNING
WARNING: Failure to install the screws or fixing
device in accordance with these instructions
may result in electrical hazards.
To install the appliance please follow these
instructions:
• The appliance must be installed by qualified
technicians, or where possible use a Sirius
recommended installer. See siriusbrand.com.
In order to avoid damage to the electronic parts
of the appliance, please do not use additional
screws.
1. Prepare the power supply - 240 volts.
2. Prepare a hole for the exhaust: (Ø 210mm for
1200.
• Maximum length of ducting should not exceed
7 metres.
• Do not use screws to fix the ducting to the
rangehoods as they will prevent the movement of
non-return valves.
• Limit the number of elbows in the ducting, since
each elbow reduces the duct efficiency by 1
metre. (i.e. if you use two 90° elbows, the length
of ducting must not exceed 5 metres.)
• Avoid abrupt direction changes.
• Use constant diameter ducting for the whole
length for the rangehood (Ø 200mm ducting for
1200).
• The use of Sirius ducting will increase the
warranty of the unit to 6 years.
(Fig. 3a)
(Fig. 3b)