4
5
A:
Mounting plate
B:
Ceiling plate cover
C:
Rangehood body, motor, filter, and light
• Dimensions:
480mm x 460mm
• Weight:
17.5kg
• Noise:
63 dBA
• Filters:
Stainless Steel with Carbon
Re-Circulating Insert
• Airflow:
600m
3
/h
D:
Power cable
TECHNICAL SKETCH
• Before installing the appliance read all these
instructions carefully.
• Make sure that the package is intact and all
the parts are in good condition, otherwise stop
the installation and contact the dealer. The
manufacturer is not responsible for damages
caused by material handling or product
installation.
• Extract the product from the packaging and lay it
on a suitable place on a soft material.
• Take the mounting plate out of the packaging
(Fig.1); to install the hood, position it in the
desired place of the ceiling, making sure the
centre of the plate is aligned with the centre of
the hob.
• Check that the ceiling structure is suitable to bear
the weight of the appliance
(weight: 17.5kg)
.
Mark the holes to be drilled at the smaller
openings of the plate (Fig.2).
• Drill the holes using an 8mm diameter drill.
Fix the plate to the ceiling, by using the plastic
dowels and the screws supplied with the
appliance. Take the ceiling plate cover out of the
packaging and then introduce the power cord
and the three steel wires into the holes (fig.3).
INSTALLATION
(Fig. 1)
(Fig. 2)
(Fig. 3)
• Place the appliance close to the ceiling plate,
and then insert the steel wires into the specific
supports, as shown in Fig. 4.
• Adjust the hood desired height, paying attention
to keeping the appliance perfectly in line with the
floor by sliding the steel wire inside the support;
you will need to loosen and push the support in
order to allow the wire to slide, see Fig. 5.
• Secure the steel wires by tightening the support
and screwing it as shown in Fig.6.
• Use some clamps in order to further secure the
steel wire, see Fig. 7.
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
Perform the electrical connection.
Place the ceiling plate cover in such a way as to hide
the plate previously mounted, then secure it by using
the three
10mm screws
provided (fig.8).
(Fig. 8)
