8
9
FITTING THE FLUE COVER
3. Fix the lower telescopic section of the bracket to
the top of the rangehood by lining up the 8x fixed
threaded bolts with the 8x pre-drilled holes on the
lower bracket and fitting the 8x nuts and washers
and tightening up fully. (Fig. 3)
4. Measure the required height to telescope the
bracket to its desired length and secure in place
using the supplied 10mm screws. (Fig. 4)
5. At this stage you will need to secure your 200mm
ducting to the outlet collar on the hood as it will
not be able to be done once the unit is hung in
place. (Fig. 5)
6. Slide the stainless steel flue cover (covers if
required) over the telescopic frame and lift the
whole hood into position. Depending on the height
of the ceiling the flue cover may need to be cut to
height. (Fig. 6)
7. Lift the rangehood with the telescopic frame and
the 200mm ductwork attached and slide the
telescopic frame inside the top mounting bracket
until the spring loaded clips engage.
Fit the telescopic frame in place securely using the
supplied 10mm screws. (Fig. 7)
x 8
x 8
10mm screws
(supplied)
Screws
Screws
Screws
Screws
200mm ducting
(not supplied)
Flue cover
Lift unit up
to bracket
Bracket fixed
in ceiling
Spring loaded
clips
10mm screws
Spring loaded
clips
Fig. 5
Fig. 4
Fig. 3
Fig. 6
Fig. 7
