Sirius Range Hoods SU906-L, Installation Instructions Manual, Page: 8 / 28

Installation SUTC919-L
Remove the grease filters before installing
the product, in order to avoid damage to the
appliance.
Open the glass by rotating it as shown in fig.
15; then remove the grease filters by acting
on their specific handle and rotate them to
remove them from their seating (fig. 16).
Make an opening on the bottom of the
kitchen cabinet having the following sizes:
SUTC919 520: 265mm X 498mm - 10”
7/16
X 19”
39/64
SUTC919 850: 265mm X 835mm - 10”
7/16
X 32”
7/8
Make sure the cabinet structure and the ma-
terial used allow you to make this opening
without causing any damages, even during
the appliance installation.
Prepare the power supply inside the cabi-
net.
Prepare the air discharge hole for the pro-
duct being installed either in the sucking or
filtering mode.
Use an air discharge pipe whose maximum
length does not exceed 5 meters.
Limit the number of elbows in the piping, as
each elbow reduces the air capacity of the
hood of about 1 linear meter. (Eg.: if you use
no. 2 x 90° elbows, the length of the piping
should not exceed 3 meters).
Avoid abrupt direction changes.
Use a 150mm.
constant diameter pipe for the whole length.
Use piping approved by standards in force.
Remove the fixing screws of the rear steel
bar, as shown in fig. 17.
Rotate the steel bar, including the led bar, to
remove it from its seating (fig. 18 - 19). You
can electrically disconnect the bar by acting
on the specific connector.
8
Place the appliance inside the cabinet and
fix it by inserting the screws supplied into the
holes, as shown in fig. 20.
Both in the front and rear side of the applian-
ce, refit the stainless steel bar previously re-
moved, connect the led bar electrically by
means of the specific connector, and then
refit the grease filter.
Rear air outlet.
Models equipped with only one motor can
be installed having the motor air outlet orien-
ted towards the appliance rear side.
If you choose this option, you will need to
remove the motor support by removing the
18 screws (fig. 13), taking out and rotating
the support, placing it in its housing , always
keeping the air outlet oriented towards the
appliance rear side. (fig. 14).
Secure it by using the screws previously re-
moved.
Blocking of the stop valve Warning!
Before connecting the flexible exhausting
pipe to the motor, make sure the stop valve,
which is on the air outlet of the motor, can
swing.
Exausting version
Connect the flange to the exhausting hole
with an appropriate pipe. Connect the ap-
pliance with the electrical mains through the
supply cord.
Filtering version
Connect the flange with a pipe suitable to
convey the air to the top of the cabinet. Con-
nect the appliance with the electrical mains
through the supply cord.