Sirennet SNLBL10, Installation & Operation Manual

Page: 7 / 12

Page 7 of 1 2
Traffic Arrow Function s:
Selecting the Traffic Arrow Sequence and Warning Flash Patterns :
Th is lightbar is designed to offer user selectable traffic directing flash sequences. Each of the Traffic Arrow functions
(LEFT, CENTER-OUT, RIGHT) can be configured individually for unique sequences and flash rates. This allows the greatest flexibility when controlling
the various light bar configurations available. The lightbar will come from the factory with Building Fast (Mode 1) as the default for LEFT, CENTER-
OUT and RIGHT. If it is desired to change the sequence for any of the functions, follow the configuration procedure below.
STEP 1: Power-up the light bar. Apply +power to the appropriate wire for the Traffic Arrow function that you wish to configure (LEFT - RED , CENTER-
OUT - RED and ORG , RIGHT - ORG ). Programming will not work if more than one function is selected at a time.
STEP 2:
Continue applying power to the wire from Step 1. Refer to Table
3
for the available
Traffic
Arrow function. To increment to the next
mode
,
momentarily hold the BLK/RED wire to +power for less than two seconds and then release. The four corner light heads will turn on steady to indicate
that the function has been incremented. To decrement to the previous
mode
, momentarily hold the BLK/RED wire to +power for two to four seconds
and then release. The four corner light heads will turn on steady and then turn off to indicate that the mode has been decremented. After the BLK/RED
wire has been released, the new mode will begin to operate and is automatically stored each time. Notice that for the LEFT, CENTER-OUT and
RIGHT functions there are four sequence
(mode)
choices (Building, Building with 3 Flash, Traveling Ball with 3 flash, and Build/Collapse) and three
speeds (Fast, Medium and Slow). There are a total of four select able modes for each of the 4 function s and then you return to the top selection (Mode
1)
. Flash
patterns
marked with an asterisk “*” can be selected in Fast, Medium or Slow flash rate.
NOTE: To restore the Factory Default Mode for any of the 4 T raffic Arrow Functions , hold the BLK/RED wire to +power for more than four
seconds. The four corner light heads will turn on steady, turn off and then turn on steady again to indicate that the Factory Default Mode
has been restored. Only the T raffic Arrow Function that is activated will be restored. You can only restore the Factory Default to 1 Function
at a time.
STEP 3: Repeat steps 1 and 2 for each Traffic Arrow F unction as desired.
TABLE 3 : TRAFFIC DIRECTING & TRAFFIC WARNING FLASH FUNCTION S
MODE LEFT (Red Wire) CENTER-OUT (Red & Orange) RIGHT (Orange Wire)
1 Building Building Building
2 Building, 3 Flash Building, 3 Flash Building, 3 Flash
3 Traveling Ball, 3 Traveling Ball, 3 Traveling Ball, 3
4 Build/Collapse Build/Collapse Build/Collapse
All sequences have a fast,
medium or slow speed.
All sequences have a fast, medium or
slow speed.
All sequences have a fast, medium or
slow speed.