XCU Installation manual supplement -
Cables and connectors
Doc. ID: XCU Installation manual supplement - Safety, cables and connectors v5.docx
Authors: Wouter Hermelink, Peter de Konink
Page 1/5
Applicable products
Product(s):
XCU-F (XCU-Fusion)
XCU-C (XCU-Compact)
XCU-C-T (XCU-Compact Thermal)
Document revisions
v3
2019-06-26
•
Power connectors: M12 5p & Conec 5p
•
Cable length and overvoltage added
•
First published version
v3.1
2019-08-28
•
Relay 1 and 2 changed to I/O output 5 & 6
•
Relay contact ratings added
v3.2
2019-11-04
•
M12A-5p option removed
v4.0
2019-07-25
•
Internal connections to Glendale boards added (not published)
v5.0
2020-12-21
•
Added safety rules “Before you continue” and “Install de unit”
•
Internal connections to Glendale boards removed (factory only)
Before you continue
●
Prior to installation and operation, carefully read all instructions in this manual and heed
all warnings.
●
Unpack this equipment and handle it carefully. If the package appears to be
damaged, notify the shipper immediately.
●
Use the original packaging to transport the unit. Disconnect power supply before
moving it. In case of returning the equipment, the original packaging must be used.
●
Any change performed on the unit that is not previously approved by the
manufacturer will void both the certification and the warranty.
●
Before performing any operation, turn off the power. The installation of the unit can
be performed only by qualified personnel in accordance with the relevant code of
practice and with all the relevant local and national standards including but not
limited to the use of special pipes, tapes, sealants, cables and glands.
●
For security reasons, install the unit out of the reach of children.
●
For security reasons, do not install the unit in the proximity of water
containers and never push objects or pour liquids into the unit. The unit can
be safely used in damp environments or outdoors, as long as the glands or
connectors are properly sealed.
●
When leaving the unit unused for long periods, disconnect supply cables.
●
Connecting GND/Earth/PE to line or neutral may result in damaging the device and
will void the warranty.
●
When a fibre optical cable is used on the equipment it shall be suitably protected
against mechanical damage.
●
The camera must be installed so that the risk of impact on the glass or germanium
window is low.