5
of
7
|
P a g e
Connection board
Field installation
ID
Name
Notes
M1
Supply voltage
Depending on model: 24VAC (max current: 6A) or 230VAC 50/60Hz (max current: 0,75A).
PE (Protection Earth) must be connected.
M7
Auxiliary AC output
Designed to activate washer systems. Generally activated via AUX 2 in Pelco D. The
activation lasts 5 seconds.
CN2
Ethernet
100base-TX fast Ethernet connection
Pre- or not connected (Not to be changed)
ID
Name
Notes
M3
Supply voltage
Supply voltage for telemetry receiver and any 24VAC device inside the unit.
M4
Data input (RS485)
Reserved. (Pelco D Protocol to control telemetry receivers: 2400,N,8,1).
M5
RS485 bus
Communication bus (RS485) for telemetry receiver. This provides the auxiliary DC output
(M7).
M6
Auxiliary DC output Reserved. (12 VDC. Max: 0,4A. Any connection of this Aux must be performed inside the
base junction box.)
M8
Auxiliary AC output
Auxiliary AC output connected to AUX 2 of telemetry receiver.
M9
Auxiliary data
(RS485)
Reserved.
M10
Auxiliary digital
input
Reserved: (Dry contact or open collector auxiliary input. Close IN1 (Collector) to Com IN
(Emitter) to activate AUX1 (wiper). Close IN2 (Collector) to Com IN (Emitter) to activate
AUX2 (washer). Com IN=GND.)
CN1
Ethernet
Fast Ethernet to IP camera
CH1_IN
Analog input
Reserved
CH1_OUT Analog output
Reserved
CN3
Auxiliary connector
Reserved
CN4
Same as above
Reserved