4
Dome camera setup
This chapter describes the dome camera setup. For information about the mechanical
installation procedure, see the Supplementary Installation Information document.
In This Chapter
4.1
Switch definition
It is necessary that the dome ID and communication protocol remain in the default modes
when connecting the HSD626EXP to other devices. The switches used for configuring these
settings are located on the bottom of the dome camera. These settings are preset to operate
the camera with the IP hardware. Changing the settings may make the camera inoperative
using the IP connection.
Refer to the figure and table below for switch location and definitions.
HSD626EXP switches
13
