12
ASSEMBLY INSTRUCTIONS….cont
Note:
Ensure that the bar is approximately 90° to the clamp and the
chain is well clear of the stand before tightening the eye-bolt. Once tight-
ened, test the arc of travel by hand to make sure that the moving parts of
the chainsaw does not touch any part of the saw bench.
5. Fit the guard (M) onto the pivot clamp (N), use the bolt (M8x70) and nut (M8) to
secure (Fig. 5).
Note:
The pivot clamp support can be adjusted vertically, to match the
dimensions of different saws and logs.
Fig. 1
Pivot Support
Clamp
Fig. 3
Measuring Rod
Support
Fig. 2
Bolt
Eye Bolt
Measuring Rod
Support
Measuring Rod
1. Carefully lower the chainsaw bar into position between the two solid blocks in the
pivot clamp. Ensure that the brake on the saw still operates when the saw is fully
seated; slide the saw in / out until this is achieved. (Fig. 6).
2. Once the saw is in the desired position secure in place with the eye-bolt (M12x30).
(Fig. 7).
Fig. 4
Measuring Rod
R-Clip
Fig. 5
Guard
Pivot Clamp
Bolt
ATTACHING THE CHAINSAW
5
SAFETY INSTRUCTIONS….cont
ble danger to the user and void the warranty.
DANGER!
Check that the saw horse is in sound condition and good working order
before each use. Take immediate action to repair or replace damaged parts.
Use recommended parts only
- Unapproved parts may be dangerous and will invali-
date the warranty.
WARNING!
Never stand on the saw horse or use it as an improvised ladder.
WARNING!
Do not allow untrained persons to use the saw horse and do not operate
when under the influence of drugs or alcohol.
DO NOT
dismantle or tamper with the saw horse, as this may be dangerous and will
invalidate the warranty.
ALWAYS
make sure the load weight is not exceeded, this will cause damage to the
saw horse and cause personal injury.
If a problem with the saw horse is experienced contact your distributor for repair.
Never
exceed the rated capacity of 120kg.
Never
use a chainsaw guide bar longer than 450mm, this is dangerous and could
lead to personal injury, or injury to others.
Never
use wood that is longer than 1800mm and 200mm in diameter, this will
cause the saw horse to be unstable and unsafe to the operator and bystanders.
Never make any alterations to this product.
Failure to follow the warnings in this manual, may result in personal injury and/or
property damage.
Before using the saw horse, ensure all nuts and bolts are tight on the stand and
guard.
When using a chainsaw (not supplied) with this saw horse, it is vital that all safety pre-
cautions are followed by the chainsaw manufacturer, if in any doubt contact the
chainsaw manufacturer for more information on safety precautions.
Always use safety goggles or safety glasses & dust mask, when using this saw horse
with a chain saw.
The saw horse is not a substitute to the normal safety gear used during chain sawing
operations.
Never wear loose fitting clothes and tie long hair etc. to ensure that they cannot get
dragged into moving parts on the chainsaw.
Ensure the nuts and bolts on the pivot clamp and guard are kept tight at all times.
Caution:
The warnings and cautions mentioned in this user manual can not cover all possible con-
ditions and situations that may occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product, but must be applied.
Danger:
Never overload the saw horse during operation, overloading can lead to
personal injury or damage to the saw horse.
