SIP 01944, Product Manual, Page: 14 / 28

ASSEMBLY INSTRUCTIONS
14
ASSEMBLY INSTRUCTIONS
INSTALLING CHISEL & DRILL BIT
1. Loosen the lock screw shown in Fig.1.
2. In order to access the chuck, undo the lock screw of the plastic cover and pull
the release tab Fig.2.
3. Loosen the chuck with the chuck key provided with the machine.
4. Place the drill bit inside the chisel. Note: These items are sharp, wear safety
gloves when assembling.
5. Insert the chisel into the bush and the drill bit into the chuck together. Push the
chisel up as far as possible into the head. Tighten the lock screw just enough to
hold the chisel in place. Make sure you set the slot in the side of the chisel to
the left or right, NOT to the front or back. This will allow chips to escape when
cutting mortises. Push the drill bit up through the chisel as far as it will go.
Tighten the drill bit with the chuck key enough to hold it in place. Then lower
the chisel head using the handle. Set the "drill to chisel height" approximately
0.8mm to 1.6mm, depending on the type of wood being worked. See Fig.1. Re-
tighten the screw to hold the chisel in place.
6. Lock the drill bit in place with the chuck key. See Fig. 3.
7. Close the plastic cover of the chuck access and screw the lock screw.
Next set the chisel square to the back fence of the table. Use the operating handle
to lower the chisel down to the table. Adjust the table forward until the back fence
touches the chisel. Check the back face of the chisel is square to the table fence and
adjust as necessary.