Page 17
It is extremely important that the following lubrication schedule be followed:
Bearings: use a good
quality multipurpose grease. Replace all damaged or missing grease zerks immediately. Always clean zerks
before using grease gun. Pump the grease in slowly until a slight bead forms around the bearing seals. Once
a month check lines and connections on grease banks for leaks.
Oilbath Oil:
Use a good high quality universal oil. Use an oil that meets or exceeds hydraulic oil grade. Fill
to the top lower oilbath roller chains. Change yearly or whenever contaminated.
Before operating a new mixer,
the roller chains should be liberally lubricated and then the unit operated un-
der a no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus
minimize heat-up during operation.
•
•
•
LUBRICATION
INTERVAL
COMPONENTS
1
8-10 HOURS
REAR AUGER BEARINGS (6 ZERKS, 3LH & 3RH)
INPUT SHAFT HANGER BEARINGS (4 BEARINGS)
PTO JOINTS (2) AND SLIDE
FRONT AUGER BEARINGS (2 BEARINGS)
DISCHARGE BEARINGS (IF APPLICABLE) AND PIVOTS
2
20 HOURS
DOOR GUIDES AND PIVOTS (SPRAY LUBRICANT)
WHEEL BEARINGS (2)
DISCHARGE CHAINS (IF APPLICABLE)
3
50 HOURS
OIL BATH (CHECK LEVEL)
4
ANNUAL
REPACK WHEEL BEARINGS
DRAIN AND REPLACE OIL BATH OIL
,)$33/,&$%/(
Summary of Contents for TURBO-MAX 6141
