Sinterit SANDBLASTER User Manual | 7
5. Initial startup of the Sinterit SANDBLASTER after delivery
1.
Remove all the solid protective packaging.
2.
Gently pull out the SANDBLASTER and accessories.
3.
Remove the bubble wrap and place the machine on a
stable surface.
4.
Screw the Adjustable mounting feet
E
(4 pieces) to
the SANDBLASTER’s base and place the machine at
its working destination.
5.
Screw the Pneumatic nipple
F
to the Pneumatic inlet
nipple
12
in the SANDBLASTER (side with thead and
Teflon tape).
6.
Connect the T-type push-in pneumatic fitting
H
to
the Pneumatic nipple
F
and then, on both sides, the
Pneumatic tubings
L
,
M
.
7.
Plug the Control pedal’s pneumatic tubings (red and
blue)
I
and the Control pedal
J
into the Control
pedal input fitting
13
in the SANDBLASTER. Make
sure that the pneumatic tubings are well connected
(suitable colours under the SANDBLASTER).
8.
Plug the Air blow gun
G
into the left tubing
L
and the
compressor into the right tubing
M
(the compressor
is not included in the Sinterit SANDBLASTER set).
9.
Unlock the SANDBLASTER lid
6
with the lid lock
10
and open it. Remove the transport protective
elements inside the machine.
10.
Check the fitting and tightness of the Protective
Rubber Gloves
2
, the Nozzle
5
and the Air filter
3
.
11.
Put on the Protective Dust Mask and Protective
Glasses (e.g. you can use the „PERSONAL
PROTECTION” set included with Lisa printers).
12.
Pick up the two parts of the grille at the bottom of the
SANDBLASTER’s chamber
11
. To raise the grille, look
for the hole marked with an arrow. It is located on the
left side of the SANDBLASTER chamber. Insert your
finger into the hole, pick up the grille and pull it out of
the SANDBLASTER. Gently add the Abrasive Material
N
(add not more than 4.53 [kg]/ 10 [lbs]). Insert the
grille back into its place.
13.
Remove all the stickers inside the chamber
11
before
first use.
14.
Check that the PE protective foil
D
of the
SANDBLASTER viewing window
6
is installed (it is
on default), clean it with a soft cloth if necessary.
15.
Close the SANDBLASTER lid
6
firmly.
16.
Plug the Power supply
A
into the SANDBLASTER
Power socket
7
. Plug it into the electric outlet.
17.
Turn on the SANDBLASTER with the Power switch
8
.
BLUE
RED
Image 4. Correct connection of the Control pedal pneumatic
tubings to the Sinterit SANDBLASTER
(blue and red).
Image 5. Correct connection of all tubings and cables
in the Sinterit SANDBLASTER.
18.
Check that the LED light
4
is working.
19.
Turn on the compressor. Check all pneumatic tubings and joints for leaks.
20.
If there are any leaks, tighten the Pneumatic nipple
F
to the SANDBLASTER with the included wrench
K
.
