16 | Sinterit SANDBLASTER SLS User Manual
1. Disconnect the sandblaster from the Power supply
and the compressor.
2. Remove the grid
24
carefully from the chamber
9
.
Put it on the work tray (so as not to contaminate the
workplace).
3. Prepare a container for used Abrasive material.
4. The plastic cork for removing the Abrasive material
from the chamber is located iat the bottom. (Image
10).
5. With the help of another person, slide half of the
sandblaster out of the worktop.
6. When one person is holding the sandblaster, the other
person must place the container under the bottom of
the sandblaster and unscrew the cork.
7. When the chamber of the sandblaster is empty, insert
the cork in place and move the sandblaster to the
workplace. Treat used Abrasive material as industrial
waste.
8. Pour new Abrasive Material into the hole in the corner
of the Chamber grid
24
. Add not more than 10 kg/22
lbs.
9. Put the grid in place. Be careful not to damage the
components inside the sandblaster chamber.
10. Connect the Power supply and the compressor.
Image 10. Removing used Abrasive material.
7.2 Replacement of the ceramic nozzle from the inner air blow gun
1. Disconnect the sandblaster from the Power supply
12
and the compressor
14
.
2. Unlock the door locks
6
and open the Door
8
.
3. Remove the Inner air blow gun
22
.
4. Unscrew the nozzle lock and pull the ceramic nozzle out of it.
5. Clean the Inner air blow gun of any possible dirt and powder.
6. Insert the new ceramic nozzle
D
into the nozzle lock nut (remember, that they have different dimensions).
7. Tighten using the supplied wrench
F
. Put the Inner air blow gun back into the sandblaster.
7.3 Replacement of protective rubber gloves
1. Disconnect the sandblaster from the power supply and the compressor.
2. Unlock the door locks
6
and open the Door
8
.
3. To loosen the metal clamp around Protective rubber glove
6
, twist off the clamping screw.
4. Gently remove used Protective rubber gloves.
5. Clean the surface thoroughly from dirt.
6. Fit the Spare Protective Rubber Gloves
M
.
7. Mount the metal clamp back in place and tighten the clamping screw.
7.4 Maintenance of the Viewing window
1. Use a soft cloth or paper towels to clean the sandblaster Viewing window
3
.
2. When the Viewing window
3
itself is damaged, replace it by safety glass with the same thickness and
measurements. Contact with Sinterit Support.
3. Poor visibility inside the sandblaster can be caused by damaged PE protective foil
19
, which is placed on the
Viewing window
3
(inside the chamber). This can easily be replaced by new foil (the five spare PE protective foils
U
are available in additional accessories of the Sinterit SANDBLASTER SLS).
•
Remove the old PE protective foil
19
.
•
Clean the inside of the Viewing window
3
with a soft cloth (it is best to soak it with alcohol).
•
Wait until all it dries and carefully place the new PE protective foil
U
.
