14 | Sinterit ATEX Vacuum Cleaner USER MANUAL
ATTENTION!
•
The highest efficiency of the powder separator can be achieved by maintaining an even air
and powder flow.
•
Always suck in the powder and air, and then the separation will take place correctly, with less
lost powder entering the vacuum cleaner.
3. For proper operation of each device (vacuum cleaner/separator), it is necessary to leave some free space in the
container in order to keep the air access.
4. The capacity of the collected material in powder separator should not exceed 3/4 of the container. Risk of sucking
in excess powder through the vacuum cleaner (Image 12).
POWDER
ONLY 3/4 OF THE CONTAINER
MAX 3/4 HEIGHT
MAX 3/4 HEIGHT
Image 12. Maximum capacity of the powder.
8. Removing powder from the Sinterit Powder Separator
1. Wait at least 1 minute after switching off the vacuum cleaner. The powder inside the powder separator must fall
freely.
2. Unlock and lower the Clamping ring
6
.
3. Lift the body of the powder separator
1
carefully and disconnect it from the Metal container
8
.
4. Place the powder separator body on the work tray so that the powder from the bottom of the Container lid does not
pollute the surface around.
• If you have a spare Metal container (e.g. from the Sinterit Powder Sieve), you can install the powder separator
on it immediately.
WORK TRAY
OR
SPARE METAL
CONTAINER
Image 13. Two ways to work safely and clean with the powder separator.
