3
3-5 Quick guide for installation and use - Strider Transmitter Link
Strider Link Series
SRFStrider-161004A-REV.A
Sinteck Sistemas Eletrônicos Ltda.
This chapter contains the necessary instructions for the installation and use of the
equipment. In case some aspects are not totally clear, for instance when a user is using this
equipment for the first time, we advise the new user to read carefully the entire description
contained in this manual.
3-2-1 Preparation
Unpack the transmitter unit and check, before making any operation, that the unit has not
suffered from any mishandling during the transport. In particular check that all the
connectors are in perfect conditions.
Check that the supply voltage value coincides with the AC voltage available.
The input supply field is of:
Strider Transmitter Link: AC mains 85 ~265V
Check that the power switch of the Strider Transmitter Link is in the position “OFF”.
The Strider Transmitter Link has just one power switch, located in the front panel, this switch
is responsible to connect the AC power or the DC power (+12V battery).
Connect the RF output of the Strider Transmitter Link to the antenna cable or to a dummy
load adapted for the working frequency and the power output used.
Connect the power cable to the corresponding VDE socket.
REMARK: it is essential that the AC network has an accurrate grounding system order to
ensure both the safety of the users and the correct functioning of the unit.
If the user intends to use external batteries in caso of AC supply interruption, connect them
to the clamps situated at the back of the equipment being careful to respect the polarity.
Connect the audio cables of your own audio signal to the apropriate connectors located at
the back of the Strider Transmitter Link.
3-2-2 Using
Switch on the Strider Transmitter Link by putting the power switch on the position “ON’.
The following message must be viewed:
SINTECK
UHF TRANSMITTER
SINTECK
UHF TRANSMITTER
03/P/24