8
3 Product operations
2 Long press the “plan” button in the remote controller for 3 seconds into the plan mode, and set
a speci c time according to “up, down, left and right” direction button.
3 Press the on/off button to save the settings, and to cancel the plan, press the “plan” button
again (During the operation, the machine is always on the standby status.)
Attention:
1 Set clock for your remote control before cleaning, the time settings are using real time.
2 Replace the remote control batteries, reset the appointment.
3 This machine uses real time for an appointment. If power is off, you will need to make an
appointment.
4 Make an appointment for each half hour, clock settings are in minutes.
3.4 Clean mode
1.Automatic clean
1 Press the clean button on the machine directly
into the zigzag cleaning mode, if not switching,
the operating mode remains unchanged.
2 Press automatic button on the remote controller
for random cleaning, and the process is the
zigzag cleaning mode, xed cleaning mode and
edgewise cleaning model.
Attention:
Machine in any cleaning mode, press the remote control "on/off" button or sweep button on the
machine to stop working.
2.Spot cleaning
1 Place machine in clean area, press the remote
control's "SPOT " button on the machine to start
with the placement point spiral sweep.
Attention:
2 After the spot cleaning is completed, the
machine will automatically enter zigzag cleaning
mode.
3 Remote control on the machine’s instructions
is required to point at the machine in order to
operate successfully.