Install your light switch
SW2500ZB-C4
Smart Light Switch
Installation
guide
4
3
1
Power up
the switch.
Use the provided connectors to
connect the wires as follows:
Make sure that the breaker for your switch is OFF
at the main electrical panel then remove the old
switch.
This product is only compatible with the Control4 home
automation system.
The installation of this light switch should be made by a
certified electrician and must be installed in conformity with
the national and local Electrical Codes.
This light switch requires a neutral wire. If your electrical box
does not have a neutral wire, you can either add one or
install the light switch at a different location.
Red
Black
White
Blue
Load
Line
Neutral
None*
!
Turn ON the light
Turn OFF the light
Use the provided screws to
secure the light switch to the
electrical box. Then, replace
the wall plate.
Warnings
Your SW2500ZB-C4 light switch
Light turned ON = Blue
Light turned OFF = Amber
The indicator intensity can be changed from
your Control4 controller.
Make sure to firmly tighten the wire connectors for a
secure connection. A loose connection can be a fire
hazard. Special CO/ALR solderless connectors must be
used when connecting with aluminum conductors.
*Note:
For a single pole installation, do not
remove the label on the blue wire.
For a 3-way installation, consult the 3-way
wiring diagram on the next page.
2
Indicator light
Operating voltage
Operation temp.
Storage
Standard UL
Standard CSA
120 Vac, 60 Hz
0 °C to 40 °C (32 °F to 104 °F)
-20 °C to 50 °C (-4 °F to 122 °F)
Conforms to ANSI/UL Std. 916
Certified to CAN/CSA Std. C22.2 No205
Line
Load
Neutral
(white)
Red
Black
White
Blue
Load
Line
Neutral
(white)
zigbee 3.0
Technical specifications
Maximum load:
Zigbee 3.0 profile
Frequency:
2.4 GHz
Transmission power:
+20 dBm
Receiver sensitivity:
-108 dBm
450 W:
LED, CFL, Halogen
600 W:
Incandescent
1800 W:
Resistive
1/2 HP:
Ceiling fan
