IDD-213L User Manual
15
G-Sensor message until it has collected specified groups of G-Sensor data. Groups
of G-Sensor data per message can be 50-100 and default setting is 100.
5.8 Regular Diagnostic Data Reporting
Device is able to read variety of vehicle diagnostic data, also called PID
(parameter ID), including vehicle speed, engine RPM, engine coolant temperature,
mass flow air, etc, and report up to 10 types of PID data according to configured
time interval.
The sample rate can be 2-600s and default setting is 60s.
There can be single or several groups of PID data in one PID message, determined
by groups of PID data per message, device will not report PID message until it
has collected specified groups of PID data. Groups of PID data per message can
be 1-30 and default setting is 1.
The suggested minimal interval for PID report is 10s, for example, 10s of sample
rate and 1 group of PID data per message, or 5s of sample rate and 2 groups of
PID data per message.
5.9 DTCs Reporting
Device is able to read vehicle pending and stored DTCs (diagnostic trouble code),
and freeze frame data. The backend server analyzes and displays the DTCs for
users on time to avoid high repairing cost.
5.10 Cell ID Reporting
Device reports Cell ID every 30 seconds when it loses GPS signal, this function
is disabled by default.
5.11 GPS Data Reporting in Sleep Mode
Device reports GPS data according to configured time interval during sleep. The
time interval can be 10-1440min and default setting is 60min.
5.12 Data storage/Supplementary Report in Dead zones
When there is no Cellular signal or Cellular signal is poor, GPS information
are stored, and reported after signal recovery. Supplementary report can be last
for 15 minutes at most after ignition is off.
5.13 Trip Mileage
Device reports driving mileage in each reported message.
5.14 Trip Fuel Consumption
Device reports fuel consumption in each reported message.
5.15 Driving behavior monitoring