Table of Contents
Previous Page | Next Page
TT700
14
2. Gently pull top (needle) thread until lower
(bobbin) thread comes up in form of a
loop.
3. Use the flat side of seam ripper/thread
trimmer to open up bobbin thread loop
until end is visible.
4. Pull both thread tails straight back under
presser foot.
5. Replace see-though bobbin cover by
sliding it back into place.
RAISING THE BOBBIN THREAD
1. Hold top (needle) thread and
turn hand-
wheel toward you
until needle goes to its
lowest and then its highest point.
Raise the presser foot using the presser
bar lifter.
