6
WATER SOFTENER MANUAL
MANUALE ADDOLCITORE ACQUA
CS3H - CS6H
4. CAUTIONS
5. IMPORTANT NOTICES
1.
Without reading and truly understanding the contents of ths user manual, please DO NOT perform
any operations on the control valve.
2.
Strictly prohibit leaning position when shipping, installing and using this product. Otherwise, it will
be damaged inside.
3.
During regeneration time, water from tap will NOT be softened. It is NOT recommended to use
water during regeneration otherwise, anegative effect on the regeneration result will occur.
4.
Initial a regenerate cycle after being inactivated in a long period of time, and then turn on the tap
for several minutes before resuming normal use.
5.
DO NOT disconnect power during serrvice time to keep the timer run normal that controls the
regeneration function.
6.
If water usage or hardness of raw water dramatically increases (comparing to the normal usage),
the frequency of regeneration should correspondingly increase.
7.
Hot water could cause severe damage to the softener system; for water boiler and water heater
users, ensure the total-run of the piping between the softener and the boiler is not less than 3
meters; it is recommended to install a check valve between the filter and the boiler if unabl to meet
the required piping length;
8.
The input water pressure must be between 0.15 to 0.35 Mpa, no negative water pressure allowed.
9.
No chemical allowed at the inlet and outlet connecting sectors. No excessive force which can
damage the plastic conjunction parts should be applied by any tools. Besides the machine, spare
part connection material doesn’t include in scope of manufacture’s warranty.
10.
The required environmental temperature for softner is 33.8 - 102.2°F. Please protect the
softener from frozen.
11.
Please set up a waterspout on the floor nearby the softener in case of any leaking accidents.
12.
DO NOT apply any pressure on the softener; ovoid exposure to the direct sun light and radiation
from other heating sources;
13.
Please select regeneration salt pill as regenerant.
The controlling components are driven by an electric circuit. Some programmed parameters will
be lost as a power outage over 8 hours, and water softener system will carry out the regeneration
process at the incorrect time. We strongly recommend that after a power outage, user should check
the timer or adjust it according to the appendix.
10.
La temperatura ambiente richiesta per l’addolcitore è 33.8 - 102.2 ° F. Si prega di proteggere
l’addolcitore dal gelo.
11.
Si prega di istituire uno scarico sul pavimento vicino all’addolcitore in caso di eventuali incidenti
con perdite.
12.
Non applicare alcuna pressione sull’addolcitore; evitare l’esposizione diretta alla luce del sole e
alle radiazioni provenienti da altre fonti di calore.
13.
Selezionare componente di sale di rigenerazione come rigenerante.
I componenti di controllo sono azionati da un circuito elettrico. Alcuni parametri di programmazione
andranno persi, in caso di assenza di corrente superiore alle 8 ore, e l’addolcitore eseguirà il
processo di rigenerazione con tempistiche errate. Dopo una interruzione di corrente è raccomandato
all’utente controllare il timer o regolarlo secondo l’appendice.
4. PRECAUZIONI
5. INFORMAZIONI IMPORTANTI
