SINED CH20A11CSR1, Manual, Page: 11 / 12


Insert 2 AAA batteries into the remote control (not included).

Connect the heater to a 230-240V~ 50Hz power outlet. Set the rocker switch to position II: the heater
will start operating. Warning: The remote control cannot operate the heater at this stage.

Connect the heater to a 230-240V~ 50Hz power outlet. Set rocker switch to position O: heater is off.

Connect the heater to a 230-240V~ 50Hz power outlet. Set the rocker switch to position I, the heater will
start in Standby mode, the heater light will continue to flash.

Point the remote control at the receiver. Press the "on" button, the unit heats up. Press "off", the heater
is set to standby mode.

Point the remote at the receiver and press the "1" button, the 1 hour delay timer will activate. With 1
hour delay, the heater stops heating and goes into standby mode.

Consequently, the heater can be set with a timer of 2 hours, 4 hours, 6 hours, maximum 13 hours delay.
4. CLEANING:

Disconnect the unit from the power supply;

After the unit has cooled down, the housing shell can be dried;

Do not touch the bulb element with your fingers as this contact may cause stains.

The reflector should be cleaned regularly by professionals.

Do not use abrasive or caustic cleaners!

Never immerse the device in water! Danger of death!
5. MAINTENANCE
Any maintenance or repair, including replacement of the bulb element, should only be performed by a
qualified electrician.