button
button
button
button
Under cool or heat mode, press this button to turn
to quick cool or quick heat mode. " " icon is
displayed on remote controller. Press this button
again to exit turbo function and " " icon will
disappear.
If start this function, the unit will run at super-high
fan speed to cool or heat quickly so that the ambi
-
ent temperature approaches the preset tempera
-
ture as soon as possible.
Press this button can select left & right swing angle.
Fan blow angle can be selected circularly as below:
●
●
●
●
Press "▲" or "▼" button once increase or dec-
rease set temperature 1°C(°F). Holding "▲" or "▼"
button, 2s later, set temperature on remote control-
ler will change quickly. On releasing button after
setting is finished, temperature indicator on indoor
unit will change accordingly.
When setting TIMER ON, TIMER OFF or CLOCK,
press "▲" or "▼" button to adjust time. (Refer to
CLOCK, TIMER ON, TIMER OFF buttons).
“ " may not be available. When air condi
-
tioner receives this signal, the air conditioner will blow
fan automatically.
Press this button continuously for more than 2s, the
main unit will swing back and forth from up to down,
and then loosen the button, the unit present position
of guide louver will be kept immediately.
Under up and down swing mode, when the status is
switched from off to , if press this button again 2s
later, status will switch to off status directly; if
press this button again within 2s, the change of swing
status will also depend on the circulation sequence
stated above.
●
●
●
、
、
When selecting " ", air conditioner is blowing
fan automatically. Horizontal louver will automat
-
ically swing up & down at maximum angle.
When selecting " ", air condition
-
er is blowing fan at fixed position. Horizontal
louver will stop at the fixed position.
When selecting " ", air conditioner is
blowing fan at fixed angle. Horizontal louver will
send air at the fixed angle.
Hold " "button above 2s to set your required
swing angle. When reaching your required
angle, release the button.
no display
(horizontal louvers
stops at current position)
、
、
、
、
、
、
button
Press this button can select up & down swing angle.
Fan blow angle can be selected circularly as below:
N
OTE
N
OTE
no display
(st
ops
a
t
current po
si
tion)
●
2s later, status will switch to off status directly; if
press this button again within 2s, the change of swing
status will also depend on the circulation sequence stat-
ed above.
The function is only available for some models.
●
Press this button, can select Sleep 1 ( ),
Sleep 2 ( ), Sleep 3 ( ) and cancel the
Sleep, circulate between these, after electrified,
Sleep Cancel is defaulted.
Sleep 1 is Sleep mode 1, in Cool modes; sleep
status after run for one hour, the main unit setting
temperature will increase 1 , two hours, setting
1
2
3
Having set X-FAN function on: After turning off the
unit by pressing " " button indoor fan will continue
running for a few minutes. at low speed. In this per-
iod, Hold fan speed button for 2s to stop indoor fan
directly.
Having set X-FAN function off: After turning off the
unit by pressing " " button, the complete unit will
be off directly.
●
●
●
●
Press this button continuously more than 2s, the main
unit will swing back and forth from left to right, and
then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immedi
-
ately.
Under left and right swing mode, when the status is
switched from off to , if press this button again
Summary of Contents for SIH-09BIT Series
Page 20: ......
