Sinclair MV-P09BI, Service Manual

Page: 16 / 57

12
Service Manual
ȝ
●
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
When replacing the batteries, do not use old or different types of batteries,
If the remote controller will not be used for a long time, please
otherwise, it may cause malfunction.
remove batteries to prevent batteries from leaking.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly,
Notes:
replace the batteries.
Sketch map for
replacing batteries
At unit OFF, press
"
MODE
"
and
" - "
buttons simultaneously to switch between and .
ć ̧
About Back-lighting Function
21
Combination of "MODE " and "-" buttons : 18 About switch between Fahrenheit and centigrade
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function 19
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start
The unit lights for 4s when energizing for the first time, and 3s for later press.
8
℃
Heating Function
. Nixie tube on the remote controller displays " " and a selected temperature of " 8
℃
"
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
Combination of " TEMP " and "CLOCK" buttons : About 8
℃
Heating Function 20
̧
Replacement of Batteries
Press " + " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is
displayed. In this case, pressing any button, blinks three times.
Combination of "+" and "-" buttons: About lock
17
locked, is