Sinbo SK 7332, Instruction Manual

Page: 31 / 36

- 27 -
2. To fill the kettle, remove it from the power base and open the lid by
pressing the lid release button, fill with the desired amount of water,
and then close the lid. Alternatively, the kettle may be filled through
the spout. The water level should not exceed MAX marks or sit below
MIN level. Too little water will cause the kettle switching off before
the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may
spill out of the spout when boiling. Ensure that the lid is firmly in place
before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the On/Off switch,
the indicator will light up. Then the kettle will start to boil the water,
once the water has being boiled the On/Off switch will be off
automatically. You can shut off the power by lifting the On/Off switch
at any moment during boiling water. If you want to boil water again,
only press down the On/Off switch directly to restart the kettle.
NOTE: Ensure that the On/Off switch is free of obstructions and the
lid is firmly closed, the kettle will not turn off if the switch is constrained
or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as
boiling water may result in scald, besides, don’t open the lid while the
water in the kettle is hot.
6. The kettle will not re-boil until the On/Off switch is pressed down
again. The kettle may be stored on the power base when not in use.
NOTE: Always disconnect the power supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water the boil-
dry protection will automatically switch off the power. If this occurs,
allow the kettle to cool before filling with cold water to re-boil.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool it
down completely before cleaning.
1. Never immerse the kettle, power cord or power base in water, or