Sinbo SHC 4361, Instruction Manual

Page: 3 / 12

- 2 -
Hold the clipper with the blade teeth pointing upwards. Begin starting at the center of the head at the
base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time.
STEP 2- Back of the head-DIAGRAM 2
With the 12mm guide comb attached, cut the hair at the back of the head.
STEP 3-Side of the head-DIAGRAM 3
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer 9mm or 12mm
guide comb and continue to cut to the top of the head.
STEP 4 - Top of the head-DIAGRAM 4
With the 9mm or 12mm guide comb attached, cut hair on top of the head against the direction in which
the hair normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a small hand
comb. Cut over the hand comb with the hair lifted or hold the hair between the fingers to lift it and cut
it to the desired length.
Always work from the back of the head.
STEP 5 - The finishing touches - DIAGRAM 5
Use the clipper without an attachment comb for close trimming around the base and sides of the neck.
Use the ear comb guides to get a clean line around each ear. For the required ear comb guide, angle
the clipper and lightly stroke around each ear to the back of the neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed clipper
at right angles to the head, tips of the blades lightly touching the skin and then work downwards.
TAPER LEVER( DIAGRAM 6)
This product has a taper lever located at the left side of the clipper near the blades. Adjust the lever
to change the closeness of the cut gradually and also to improve the effectiveness of the comb
attachments. The taper lever also extends the life of the blades because a different cutting edge is used
in each setting.
CARE FOR YOUR HAIR CLIPPER
Your clipper is fitted with high quality fine grinding stainless steel blades. To ensure long lasting
performance of your clipper, clean the blades and unit regularly. Always keep the protective cap on the
trimmer blade.
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning.
EVERY SIX MONTHS
At regular intervals the Blade Set should be removed and cleaned.
Remove the 2 screws retaining the fixed blade with a screwdriver. Do not remove blade set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the lubricating grease
from the blades. It is not necessary to remove the small moving blade from the unit.
If the moving blade has been removed this can be re-fitted by slotting the long grooved edge of the
blade onto the two white plastic guide ridges and then seating the blade oven the plastic actuator bar.
The fixed blade is fitted with the raised profile pointing outwards and fixed with the 2 screws.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and align the blades
so that their cutting edges are parallel to one another. Tighten the 2 screws. Note that if the blades are