4
ELECTRICAL SETUP
1.
Charge Level:
indicators for the battery charge level.
2.
Charging:
indicates when the solar panel is charging.
3.
Battery OK:
Battery check LED.
BATTERY CONDITIONS LEDs
FIGURE 3
8.8m
5.8m
2.7m
8.8m
5.8m
2.7m
8.8m 5.8m 2.7m
2.4m - 4.8m
0
0
PIR DETECTION ZONES
1
2
3
FIGURE 4
NOTE: The unit will not operate correctly unless it is fully charged. When charging the Mightylite Solar, the
charge LED should flash red.
If the charge LED is flashing orange, this indicates a battery fault or the battery may not be connected correctly. Remove the
battery, clean the contacts with a non metallic cloth and carefully slide the battery back on.
1. Remove the lithium battery from the packaging, taking care when handling. Carefully slide the lithium battery onto the
back of the light fitting, and the unit is now ready to charge.
2. To charge the unit, plug the solar panel and light fitting together. Once exposed to sunlight the red charge LED should
flash to indicate the unit is now charging.
3. We suggest you charge the battery before installation, in direct sunlight for at least 5 hours. Keep out of reach of
children. Once fully charged remove the battery (place somewhere safe) and disconnect the solar panel.
Pre-Install
Install
4. Carefully slide the battery onto the back of the Solar Floodlight and ensure it is fully locked into place. At this point do not
plug the solar panel to the light fitting. Please take care not to touch the metal connections on the bottom of the battery.
5. Fix the battery waterproof protection cover in place with the four screws provided.
6. Plug the solar panel cable and the light fitting together.
7. Installation is now complete. To test that the unit is working satisfactory, cover up the solar panel and you will be able to
walk test the unit in daylight.
