Fig. 2
INSTALLATION INSTRUCTIONS
Unlock power switch cover and confirm power switch is in the off position (Fig. 1).
Attach mounting bracket (Fig. 2).
Remove electrical access panel and wire as per diagram (Fig. 3).
Mount hand dryer on bracket (Fig. 4).
Remove bottom air filter to access mounting hole on base of unit.
Replace air filter (Fig. 5).
Plug unit into approved power point if equipped with plug.
Turn power switch on, return switch cover and lock into place. Check hand dryer operations.
BEFORE YOU START
Note:
This unit must be fixed to a solid supporting wall and must not be mounted above shelves or
over stainless steel/reflective surface counters.
To ensure the ease of installation and subsequent maintenance of this unit the horizontal distance to any
adjacent wall should not be less than 200mm.
Fig. 1
*Measurements to
be used for fixed
wiring location
.
SERVICING AND MAINTENANCE
This unit must be isolated from the power supply during routine maintenance.
This unit should be serviced frequently to remove water from the drain tank drain. Clean dust or any
other build up from the air filter (Fig. 1).
Do not attempt to disassemble unit or during cleaning hand dryer as this may void product warranty.
Summary of Contents for FAN5655
Page 3: ...Fig 5 Fig 4 Fig 3 ...
